Ez Seal is a water-based acrylic that quickly penetrates and provides a thorough, durable seal or finish coating. Ez Seal has good gloss retention, resists oils, water vapor, alkali and many acids. Many use EZ Seal for their sealing projects over stained concrete, or to put over bare concrete. This product is great for the professional flooring installer because it is able to be re-coated in just minutes…meaning less trips to the job-site. It also is very easy to apply and is less likely to “roller mark” when applying compared to other concrete floor sealers.
Seals and heals concrete preventing dusting. Prevents pitting and staining and does not discolor when exposed to UV light. It dries quickly to keep down time to a minimum.
Surface Prep: Concrete surface must be clean and free of all contaminants and water. Do not apply if rain is forecast within 24-hours. If moisture is present or if the surface is not clean and free of all contaminants, the sealer may have white spots and have premature delamination and failure.
Substrate and air temperature must be no less than 50 degrees F and not exceed 80 degrees F. If applied outside these limits may not achieve adequate film formation and may have excessive air entrapment, bubbles, blusher or hazing. Note that in direct sunlight, substrate temperatures can exceed 150 degrees F which can cause extreme bubbling issues.
Mixing: Stir well before using material may separate during long term storage.
Application: Apply using a 3/8” long nap roller cover using long even uniform strokes at approximately 250-400 square feet per gallon. Thick or puddle areas may prevent the solvent from evaporating and may be susceptible to moisture intrusion which may cause milky white spots. Applying too thin may cause sealer to prematurely delaminate, flake or wear away. Allow sealer to dry for 24-hours for light traffic and at least 48-hours for heavy traffic. If applying two coats, wait approximately 4-6 hours between coats.
When using as a cure & seal, apply only one coat to meet specifications. Extreme bubbling and/or hazing may occur due to lack of permeability.
Please Note: It is always recommended to test the product in a small, inconspicuous area on the same concrete substrate for desired results prior to application. Coverage rates may vary for all coating and substrates depending on porosity, density, texture etc. When applying, do not exceed 400 sq.ft per gallon. Applying too thin of a coat may cause inadequate film formation or performance expectations may be limited. DO NOT USE ON BRICK.