Anti-Microbial Additive
$39.00
Our Antimicrobial additive is a liquid additive for most of our coatings (except Prothane 1) to protect against the growth of bacteria, molds and algae on the sealed surface. Treats 5 gallons.
- Description
- Note
- Mixing
- Surface Prep
- Application
Our Antimicrobial additive is a liquid additive for most of our coatings (except Prothane 1) to protect against the growth of bacteria, molds and algae on the sealed surface. Treats 5 gallons.
Can be used in any solvent based or water based acrylic sealer, polyaspartic, aliphatic urethane, or 100% solids epoxy.
NOT FOR USE IN PORTHANE-1
Anti-Microbial Additive is packaged to be mixed with five(5) gallons of sealer or coating. The mix ratio does not change based on solids, dry time, single component, multiple component, etc.
For single component sealers and costings, mix one (1) Anti-Microbial Additive per five (5) gallons of sealer or coatings for 2-3 minutes prior to application.
For two component products, mix Anti-Microbial Additive with the Resin (typically Part A) for 2-3 minutes prior to blending Part A and Part B
Refer to specific coating being used for surface prep & other instructions prior to use.
Refer to specific coating being used for application coverage rate and other instructions prior to use.
Please Note: It is always recommended to test the product in a small, inconspicuous area (on the same concrete substrate) for desired results prior to application. Coverage Rates may vary for all coatings and substrates depending on porosity, density, texture etc.
