No products in the cart.
Cherry Glo is a high gloss, non-yellowing acrylic floor polish for use on all types of sealed floors. It not only dries to a high gloss finish but can also be maintained by spray buffing.
Spread Cherry Glo in a thin even coat over the floor using a lambs wool applicator or a clean yarn mop. Allow to dry completely for about 24-30 minutes. Apply a second coat and let dry completely before allowing traffic on the floor.
Spray Buffing
- Dilute 1 part of Cherry Glo with 3 parts of water. Using a Trig Mist sprayer, mist lightly over a 10 Sq.Ft area and buff with a polishing pad until all liquid disappears and a brilliant shine appears.
- Repeat this until the entire floor is renovated and polished.
Maintenance
- Occasional damp mopping with a neutral detergent will maintain the smooth glossy surface. In heavy traffic areas, after mopping and rinsing let dry and apply a thin coat of Cherry Glo
| DATA SHEETS |   |
|---|---|
| CONTAINER SIZE | 1 Gallon |
| COVERAGE RATE | 1200 square feet per gallon |
| TYPE | Super acrylic floor polish |
| ODOR | Very Mild |
| TOXICITY | Non-Toxic |
| FLAMMABILITY | Non-Flammable |
| PH | 8.5-8.9 |
| COMPOSITION | Acrylic polymer emulsion, ethylene, copolymers, proprietary additives and quality control |
Surface Prep: Allow any coatings to fully cure for at least 3-5 days prior to applying wax. Be sure the area of the concrete to be
removed is free of trash and debris. Protect all other areas. Mask off all adjacent surfaces with painter’s tape or plastic duct tape. If
spray buffing, use a plastic or coated cardboard as a spray shield.
Mixing: Stir well before using. Material may separate during long term storage. Do Not Thin!
Application:
1. Do not apply by pouring directly onto surface. Use a plastic roller pan. Apply by microfiber dust mop, synthetic fiber wax applicator,
or lambs wool applicator.
2. Apply at a rate of 1,000 square feet per gallon in very thin coats only. Apply in one direction to a consistent, even, and uniform
finish. If puddling or pinholes appear, work them out into a thin coat.
3. Allow to dry 1-3 hours. Repeat process as many times as necessary to achieve required finish.
If spray buffing, dilute wax 1:2 with water. Apply using a trig mist sprayer over a small area at a time. Buff that area with a 300 – 500
RPM buffer in a side to side motion until the liquid has disappeared and a superior shine is left. Continue this same process throughout
the whole floor.
If burnishing, allow wax to dry thoroughly. Using a 1000 – 3000 RPM burnishing machine, work in a front to back line with a natural hair
or synthetic material burnishing pad.
Maintenance coats may be necessary every once in a while as traffic will eventually dull the surface. Simply mop the area clean using a
light, pH neutral detergent solution. Allow to dry and then apply a coat of wax to rejuvenate the smooth finish.
Warning: When applying wax over a newly sealed surface, allow 3-5 days with proper ventilation prior to wax applicaton. Failure to
allow this window could result in blushing of the wax.
PLEASE NOTE: It is always recommended to test the product in a small, inconspicuous area (on the same concrete substrate) for
desired results prior to application. Coverage rates may vary for all coatings and substrates depending on porosity, density, texture etc.
DO NOT USE ON BRICK.
Additional Information
| Weight | 10 lbs |
|---|---|
| Dimensions | 6 × 6 × 13 in |